Dickinson Lofoten Manual del operador

Dickinson Marine #407-204 Cayer St Coquitlam BC Canada V3K 5B1 www.dickinsonmarine.

-8A- installed as per diagram. Place the check valve as shown in the diagram on top of the heavier replacement spring, and the spring on top of the p

-8B- #20-002 FRD-HD c/w REGULATOR We recommend using an elbow fitting on the fuel inlet. When priming this pump hold down the knob of the pres

-9- Use 3/8" (9.52 mm) copper fuel line for the first 2-3 ft closest to the heater/stove. Approved hose can be used for the remain

-10-

-11- Fuel Variations It is unlikely that the fuel you are using is the same viscosity as the fuel used to calibrate the oil-metering va

-12- Fuel Flow Measurement If your stove is burning rich (making soot or smoking

-13-

-14- Oil Metering Valve Information & Rebuild Instructions #02-200 Do not plug the overflow fitting. A fuel line must be take

-15- Code 3 is for the size of heater/stove (all models with a 6” burner) Code 4 is for Atlantic stove Code 5 is for Beaufort stove The “D” is for #2

-16- • Place the new needle in the seat and slide the new float on so the flat bracket groove catches the neck of the needle. • Insert the

-1- CONTENTS Warnings and Disclosures pg-2 Burner Assembly pg-17

-17- Valve Safety Features A Flame out relates to the oil level and the float level in the oil metering valve. In the event that the stove f

-18- Combustion Air To guarantee that sufficient oxygen (fresh air) is available for your stove, good ventilation is essential. It is ne

-19- Your stove is a natural draft appliance and it creates its draft pressure like a chimney in a wood stove. The rising, heated air in the stack pul

-20- Installation Check-List for a Natural Draft Oil Heater / Stove A permanent 3” dia. fresh air vent to provide your heater/stove with the

-21- Lighting Instructions 1. ENGAGE PUMP OR OPEN GRAVITY FEED VALVE TO ALLOW FUEL INTO THE ME

-22- The first time the oil-metering valve is turned on it will take 5-10 minutes for the fuel lines to fill and oil to appear in the bottom of the

-23- Operating Tips Every time the position of the knob on the oil metering valve is moved (fuel), th

-24- Flooding Burner A vaporizing oil burner of this type can be flooded if care is not taken to prevent excess oil entering the burner when

-25- The coils in a stove can be used to heat the water in your existing hot water supply tank. If the tank is mounted above the lower coil the water

-26- Cleaning Burner Carbon accumulates in the burner over a period of time and it must be cleaned out. It is especially importa

-2- Warnings and Disclosures - Follow all installation and operating procedures. - The oil stove requires an installed flue for correct operation

-27- Cleaning Fuel Lines Any blockage in the fuel line from the oil-metering valve to the burner can be cleaned by removing the clean-out

-28- will require a re-seasoning. It is normal for your cast iron lid to require a re-seasoning occasionally. Prepare the lid by scrub

-29- Trouble Shooting - No fuel in the bottom of the burner Check the tank is vented or the pump has power and all shut-offs are

-29A-

-30- FAQ Can I burn bio diesel? yes, refer to page-14 in the manual Can I burn low carbon diesel? yes, same as bio-diesel, refer to page-14 Wh

-31- Limited Warranty WARRANTY PROVISIONS : Dickinson warrants this product to be free of defects in workmanship and materials for a period of one

-32- Return to: SINCE 1932 #407 – 204 Cayer Street, Coquitlam, B.C. Canada V3K 5B1 WARRANTY FORM I have read and understand the Limited Warrant

-3- Installation Diagram NOTE: Not all installations will require a pum

-4- Clearance Diagram Installation Guidelines Location The location of the stove must be large enough to provide safety clearances

-5- Ideally, the stove should face the bow or stern of your vessel, particularly on a sailboat. Fuel

-6- Flue Stack The length and straightness of the flue stack are important to the efficient operation of the stove. The Flue stack must be the correc

-7- The draft above the top of the fire will be aprox -.05 inches of water column, should you have a draft meter, however adjusting the damper as abov

-8- #20-000 FRD-2 3 PSI FUEL PUMP & #20-002 FRD-HD c/w REGULATOR FUEL PUMP